- 16 -
backing goes over the piston pins. When correctly inserted, the pad
will be held in place magnetically, repeat the procedure for the
other pad.
Warning: If you are unsure about any part of the installation process you
should seek advice from Wisper service center or qualified mechanic.
15 Stem handle bar clamp
15.1
Your bike has been fitted with a quick release handlebar clamp that allows you
to change the position of the bars quickly and easily to find the most
comfortable riding position.
15.2
The stem and handle bars need to be fitted before you use the bike.
15.3
To fit, insert the stem into the front tube at least to the position of the
“Minimum insertion” mark.
15.4
Tighten the quill bolt and fix stem.
14.5
Push in the direction of the arrow slide cap 1 and lift lever 2.
15.6
Adjust stem to preferred angle and lightly tighten BOLT 1 then BOLT 2
to a suitable position so that the slide cap 1 will fit when locked, then press
down lever 2 to lock the handle bars in position.
15.7
Test the bars to make certain they are tight and do not rotate. If they are not
tight enough, release lever 1, lift lever 2, adjust BOLT 2 again then press down
lever 2. Repeat until the handle bars are tight and safe.
IMPORTANT when fitting always adjust Bolt 1 first so the body and
cap touch then Bolt 2.