4
2
Caring for your Wisper bike and pre-use checks
Your Wisper bike has been thoroughly tested at the factory prior to delivery and has undergone a
pre-delivery inspection by your Wisper dealer.
It is very important that you check the bike thoroughly before its first use. Equally important are
frequent and regular spot-checks, as they will protect you and your Wisper bike.
Please read this manual carefully. Only on full understanding all of the functions of this electric
bicycle should you attempt to use it.
2.1
Before you set off for the first time
2.1.1 Check the handlebars and handlebar stem are properly tightened.
2.1.2 Check all other nuts, bolts and fixings are properly tightened.
2.1.3 Check brakes are functioning properly.
2.1.4 Check tyre pressures are correct and tyres are not damaged.
2.1.5 Check reflectors and lights if fitted, are functioning properly.
2.1.6 Make sure the battery is fully charged.
2.1.7 Load the battery onto bicycle by sliding into the rack until the battery “clicks” in place. Then
turn on with the switch located at the rear right hand side of the battery. Remove key from
battery and keep safe during operation of the bike. To remove the battery, first turn the
battery off at the switch, then turn the key and hold in the unlocked position then slide the
battery out of the rack.
2.1.8 Turn on the bike by pressing the on/off switch adjacent to the left-hand grip for two
seconds. (Turn off the bike by repeating the same process).
Fig 1
The bike will be ready to ride, and the LCD will activate showing battery state, assist level,
time, trip and speed. Turning the pedals for more than ¼ of a revolution or twisting the
throttle will now activate the motor. With the TPP upgrade installed the motor will start
when you press down on the pedals.
Other functions
1.
To set the assist levels: Toggle with the up and down arrows.
