OR/eL3QV5/ID-94199/KTM-653Y307941991/03/2016
Installation and Operating Instructions
– Radio receiver eL3V5Q
WIŚNIOWSKI Sp. z o.o. S.K.A.
PL 33-311 Wielogłowy 153
TEL.
+48 18 44 77 111
FAX
+48 18 44 77 110
www.wisniowski.pl
N =
49° 40’ 10”
E =
20° 41’ 12”
SELECTION OF OUTPUT MODE.
Monostable mode with adjustable activation time.
After receiving the signal from the transmitter, the output relay is activated for the time programmed
by the user (1 s by default) and then returns to the previous mode. The output activation time is to
be set up from 0.2 s to 7 s in increments of 0.2 s. To select this mode, press and hold the “SW” but-
ton on the controller board until the LED goes out and lights up again. Release the button (the LED
will go out). Now you have about 4 s to set up the time. Each press of the “SW” button increases
the activation time by 0.2 s (e.g. press the button 5 times to get a 1 s activation time). The time be-
tween each press of the button cannot exceed 3 s. If the time is programmed properly, the LED will
flash three times and then the controller will return to normal operation. If you fail to press the “SW”
button within 4 s, the LED will flash once and the receiver will return to normal operation without
changing the settings.
This mode is set by default (output activation time is 1 s).
Bistable mode (enable/ disable).
Each time you press the transmitter’s button, output relay changes its status for the opposite. To
select the bistable mode, press and hold the “SW” button on the controller board until the LED will
go out and light up again. Release the button. Then within 4 s press and hold the “SW” button again
until the LED will start blinking which means the procedure has been performed properly. In case of
power off, the output is switched off (open-circuit relay).
To disable the bistable mode, the monostable mode should be programmed.
RESTORING THE FACTORY SETTINGS.
To restore the factory settings (monostable mode with output activation time of 1 s), disconnect the
radio receiver power supply, and then press and hold the “SW” button and switch the power on. The
LED will flash three times, and the controller will return to normal operation with the factory settings.
DESCRIPTION OF OUTPUTS
Antenna
– 17 cm long soldered
antenna
24Vac
– power supply
(red wires)
CH
– output
(white wires)
SPECIFICATIONS
Frequency:
433.92 MHz
Transmission:
according to the KEELOQ standard
Power supply:
15-24V ( acc. to configuration)
Current:
12/42 mA (maximum)
Normally open output:
1A/30Vdc , 0.5A/125Vac. For
monostable mode:
- minimum activation time: 0.2s
- maximum activation time: 7s
- activation time by default: 1s
Range:
60 metres (minimum)
www.ga
ł
ecki.pl
