WARNINGS
We strongly encourage you to read this manual before installation and use
of the product and strictly observe the recommendation hereof.
Installation shall be carried out by qualified personnel. Mounting in
-
struction has to be carefully observed.
For installation and use, please observe all specific regulation and
laws applicable in the destination country.
Carefully read all safety regulations. Failure to observe the indica
-
tions reported, can cause serious damages to third parties.
If not otherwise indicated, for tightening of screws, bolts and in gen
-
eral threaded rods, refer to applicable figures reported in Tab. 2 in the
paragraph General Installation Instructions for GIBERTINI Antennas
Gibertini srl reserve the right to change specifications to products and to documentations without prior notice.
NOTES ABOUT DISPOSAL
The barred bin symbol indicates that the product must be disposed of separately from other waste
and cannot be thrown into the domestic waste at the end of its life. The user will therefore take the
appliance at the end of its life to the suitable separated collection centres for metal parts waste in
their own town. An adequate separated collection for sending of the appliance to recycling, treat
-
ment and environmentally compatible disposal helps to avoid possible negative effects on the environment
and on health thus favouring the reuse and recycle of the materials of which the appliance is made of. The
unauthorised disposal of the product by the user causes the application of administrative fees provided for
by the regulation in force.
TechNIcAl SpecIfIcATIoNS
OA 13 A
Frequency range (GHz)
10.00 - 13.00
Feed illumination angle
70°
Outside dimension (cm)
124.5 x 133.5
Feeder clamp (mm)
40 / 23
Reflecting dimension (cm)
121.0 x 130.0
Elevation angle
0° - 90°
Illumination efficiency * (%)
70
Mast clamp (mm)
55 - 100
Gain * @ 10.70 GHz (dBi)
41.1
Alu reflector thickness (mm)
1.5
Gain * @ 11.70 GHz (dBi)
41.9
Steel reflector thickness (mm)
1.0
Gain * @ 12.75 GHz (dBi)
42.6
Antenna net weight (kg.)
alu 16,50
Cross polarization * on axis (dBc)
- 28
steel 21,20
First side lobe level * (dBc)
- 24
Wind load @ 120 km/h (kg) [worst-case]
162
Noise temp. * @ 12GHz, 36° elevation (K)
34
Working temperature
- 30° / + 70°
F/D radio
0.66
Humidity
0 – 100%
3dB Beam width* @ 11.7GHz
1.32°
Offset pointing angle
21.3°
* matched feed | Data subject to change without notice | Additional information available upon request