www.
©WISI Communications GmbH & Co. KG
3 - 8
www.wisi.de
2.3
Connecting cables
Connect the cables for HDMI input signal to each HDMI in port (1-4).
When using the GN40x, GN20x or GN01x base unit the streaming and management interface
must be connected too. When using the GN50x base unit the streaming and management
interface will be connected via the backplane connector automatically.
2.4
Connecting to the default IP address,
CHAMELEON Web UI
For GN40x, GN20x or GN01x base unit (without GT11 switch and controller):
The CHAMELEON Encoder default IP address is 192.168.0.20. Set the IP address on your computer or
for your network adaptor to an address in the same address range. Use a standard web browser to
connect by typing the IP address of the CHAMELEON Encoder in the address field.
It is recommended to change to a unique IP address in your network. You can change the IP address
under SETTINGS / NETWORKING, or by using the IP Supporter.
For GN50x base unit (with GT11 switch and controller):
The assembled CHAMELEON Encoder is connected via the internal GT11 switch and is automatically
shown on the left sight of the user menu (for example slot 8). A changing of the management IP address
is by using the GN50x chassis not necessary.
RF port is not in operation.
Only for mounting the module
in the GN40x base unit.
Status LED of the input signal
RED: no input signal or error
GREEN: input signal is locked
HDMI Input 1
Type A
Port for
Management
Port for
Streaming
