SAGE L75m
WISDOMAUDIO.COM
10
For the purposes of this manual, we will assume that you have already connected the
approved DSP Amplifiers/Processor with Active Crossovers and PEQ as per the
instructions found in its manual. As such, you should have signal coming from your
source component(s) to a preamp/processor, and then on to the signal that is split into
low-pass and high-pass sections, with the low-pass section going to one or more
Wisdom Audio SA Series amplifiers, and the high-pass section going to additional SA
Series amplifiers, which will drive the planar magnetic panels.
Connect the outputs of your Wisdom Audio SA-series amplifier to the appropriate
woofer sections, taking care to get both the channel assignments and the polarity
correct. Connect the positive (+) terminals on the SA Series amplifier to the positive (+)
terminals for the woofer on the loudspeaker; likewise, connect the negative (–)
terminals on the amplifier and the speaker, respectively.
Next connect the outputs of your chosen amplifier for the midrange/treble to the
Sage
L75m
planar sections in a similar fashion, taking care with both channel assignments and
polarity.
Care & Maintenance
To remove dust from the front of your L75m, use a feather duster or a lint-free soft
cloth.
Never attempt to clean the drivers themselves.
North American Warranty
Standard Warranty
When purchased from and installed by an authorized Wisdom Audio dealer, Wisdom
Audio loudspeakers are warranted to be free from defects in material and workmanship
under normal use for a period of 10 years from the original date of purchase.
Caution!
Do not touch the surface of the planar magnetic drivers, under any circumstances. The
thin film has been carefully pre-tensioned at the factory; any subsequent contact can
only damage it.
