SAGE L150m
WISDOMAUDIO.COM
8
Mounting the L150m on the Wall
The mounting bracket that mounts to the wall is shipped attached to the back of the
loudspeaker. It is removed by pulling “down” on it relative to the end of the speaker
that will be “up” when installed on the wall. (Note that for horizontal center channel
speakers, this means the bracket is pulled
across
the narrow dimension of the
speaker.)
It is recommended to place a screw into every open mounting hole so to
avoid the bracket possibility resonating once the speaker is mounted to the wall.
Please note that this guide assumes the wall surface is flat. If not, shims must be
applied to the rear of the mounting bracket so that the mounting bracket is uniformly
secured to the wall and flat (not distorted). The mounting steps are as follows:
1.
Locate the area with the two sets of high- and low-pass speaker cables coming
out of the wall.
2.
The inside face of the bracket assembly has arrows stamped into it indicating
which direction must be “up” when it is mounted on the wall. Align the center
screw hole in the mounting bracket next to the speaker cables and attach
somewhat loosely using a dry-wall screw (or similar),
so you can adjust the bracket for plumb.
3.
Using a bubble level to ensure that the mounting bracket is plumb, mark screw
holes for EZ-Toggle screws in end clips, using the bracket itself as your
template. You can use any opposing (diagonal) set of holes for mounting of the
two EZ-Toggle screws in each end clip.
4.
Rotate the bracket out of the way and install two of the supplied EZ-Toggle
screws in each mounting bracket end clip as follows:
a.
Using a #2 Phillips bit in your cordless drill, spin the E-Z Toggle Anchor into
the drywall until the head of the anchor is seated flush and the arrows on
the head of the anchor point up and down. Repeat this process for each
anchor location.
b.
To “set” the clamp behind the drywall, place the mounting screw into the
anchor and push or tap firmly until approximately 1" (2.5 cm) of screw is
protruding (do not rotate). Then remove the screw. Repeat for each anchor
location.
c.
Rotate the mounting bracket back over the E-Z Toggles, insert the screw
and continue to turn until fastened tightly. The screw stops when the toggle
bar secures itself against the opposite side of the drywall (
inside
the wall).
Repeat for each anchor location.
