14
Making the Hybrid Line Source Connections
As with any system, you should make changes to the connections only when the
power is turned off to avoid any chance of inadvertently causing a problem (such as a
short-circuit).
1.
Remove the cover panel on the front of the HLS Center Module
2.
Route the speaker wires from the amplifier through the access panel in the rear
of the HLS Center Module.
3.
Connect from the tri-amplified outputs of your amplifier (3 channels) to the
input of the HLS Center Module.
4.
Connect from the HLS Center Module fly leads to the Line Module on either
side of the Center Module
NOTE
: Be sure to connect the correct Low/Mid/High frequencies to the input terminals. Damage to the
speaker could result if the wrong connections are made.
Detail View of Center Module Input Terminals (From Amplifier)
Detail View of Line Module Input Terminals (From Center Module)
