2
WPS-100-DOM-A-WH Installation Manual
© 2011 Wirepath Surveillance
INSTALLATION INSTRUCTIONS
This camera is intended for indoor use only. Recommended
cabling includes solid copper RG59 or RG6 for video and 18
AWG two-conductor for power.
TROUBLESHOOTING
If you have trouble operating the camera, first refer to the
following guidelines. If the problem persists, contact Technical
Support at 866.838.5052.
Nothing appears on the display
• Check if the power for camera and monitor is ON.
• Check if the VIDEO cable is connected to the camera
BNC video output jack.
• Check if the VIDEO cable is connected to the monitor
VIDEO input jack.
Image appears dim on the display
• Check the monitor contrast setting.
• Check the monitor brightness setting.
• Check the lens. If necessary, wipe with a soft,
clean cloth.
• Check if the camera is facing towards a bright light.
If so, change the camera position.
• If a device exists between the camera and screen,
confirm the signal accepted by the screen is strong
enough – 75 Ohm.
Image appears blurry on the display
• Check the focus of the lens.
• Check the lens. If necessary, wipe with a soft,
clean cloth.
The camera is not working properly and the camera
housing is hot
• Check if camera is connected to the correct power
source.
DIMENSIONS
3.69”
3.52”
SIDE VIEW
FRONT VIEW
1. Remove the base
by gently twisting
counter clockwise.
Use caution when
seperating from
the base as camera
will be loose.
2. Position the camera’s
base in the desired
location. Use the
provided screws
to attach the
camera base to the
wall or ceiling. Ensure
the power cord
is fed through the
center of the base
and placed in the
power cord notch.
3. Connect the power
supply jack to 12
VDC and the BNC
Video Output to the
desired video line.
4. Re-attach the
camera to the base
by aligning the 3
tabs and twisting
clock-wise to lock the
camera to the base.
5. Once the camera
is installed, check
the orientation
of the housing.
The arrow on the
front of the lens
should be pointed
down.
WARRANTY
5-Year Limited Warranty
This camera has a 5-Year Limited Warranty. The warranty includes
parts and labor repairs on all components found to be defective
in material or workmanship under normal conditions of use. This
warranty shall not apply to products which have been abused,
modified, disassembled or improperly installed. Products to be
repaired under this warranty must be returned to Wirepath™
Surveillance or a designated service center with prior notification
and an assigned return authorization number (RA).
12VDC Power
BNC Video
Output
Arrow
pointing
down
