IMPORTANT INSTRUCTIONS
•
Read and understand all instructions.
•
Do not use this product near water, such as a bath tub, wash bowl, sink, pool or in a wet basement.
•
Never install wiring during a lightning storm..
•
Use caution when installing, terminating or modifying any type of wire.
WIREPATH POWERED VIDEO MODULE FEATURES
RF INPUT/ PC Modem Output
75-ohm input for Antenna and Cable signals. 1 - PC/ Modem output Non-Amplified to eliminate a need
for a 1X2 RF splitter.
All 3/8”-32UNEF/B SCTE Compliant Weather Sealer Connectors.
ENVIRONMENTAL
Die-cast Aluminum and powder coated weather sealed case can withstand the harshest of weather.
RF AMPLIFICATION
Bi-directional amplification provides 15 dB of gain in a CATV or antenna system. Outcut connector is
F-Type 54-1000MHz Frequency Range. 54 MHz to 1000 MHz forward bandwidth with 5 MHz to 42 MHz
reverse bandwidth.
Surge Protection
Built into this module is a 600Kv /B3 ANSI81-2003/IEEEC62 Circuit. This gives additional protection
to the module in case of power surge or lightning strikes.
INSTALLATION
PLACING YOUR WIREPATH STRUCTURED WIRE MODULE
Wirepath structured wiring modules are designed to fit Wirepath structured wiring enclosures. Installation
is simple with our familiar expansion pins. Plan the placement of each model in the enclosure based on
how you have wire entering the enclosure, and what will allow for the cleanest routing of wires.
If the Wirepath module is being used in an enclosure of another brand, it may be necessary to use one
of the included spare mounting pins in the extra mounting flange hole, and remove the two pins on that
side to fit the mounting pattern of other enclosures from another brand.
VIDEO CABLE WIRING
Use standard F connectors for terminating the wiring.
POWER SUPPLY
The 15 volt power supply is required for the Video amplifier to work properly.
Standard coax cable will be needed to power module. (Not Included)
or
SW Can
SW Can
TROUBLESHOOTING
Wirepath structured wire modules are designed to function trouble-free. Most problems that
occur are due to simple issues. If you have trouble, please check the list of simple fixes
below. If the problem persists, contact your authorized Wirepath dealer or Wirepath customer
service at 866.838.5052
No Video output or picture on outputs
• Power supply is connected incorrectly or plugged into an outlet that does not have power.
Check connections and verify power on the outlet. The red LED on module will be lit when
power is correctly connected.
• Verify that there is signal on any of the inputs being used.
• Check all wiring connections on output(s) with no signal including any wall-plate
connections at the remote location.
Two-Year Warranty
All Wirepath
®
products have a two-year Limited Warranty. This warranty includes parts and labor repairs on all
components found to be defective in material or workmanship under normal conditions of use. This warranty
shall not apply to products which have been abused, modified or disassembled. Products to berepaired under
this warranty must be returned to SnapAV or a designated service center with prior notification and an assigned
return authorization number (RA).
NOTE: Mounting pins are designed for flat installation when larger cable loads
are connected. To mount horizontally with full cable loads it is recommended to
use screws (not included).
