2
WPS-150-BUL-A Installation Manual
© 2014 Wirepath Surveillance
WARRANTY
5-Year Limited Warranty
This camera has a 5-Year Limited Warranty. The warranty includes parts and labor repairs on all components found to be defective
in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused,
modified, disassembled or improperly installed. Products to be repaired under this warranty must be returned to Wirepath™
Surveillance or a designated service center with prior notification and an assigned return authorization number (RA).
INSTALLATION INSTRUCTIONS
Recommended Cabling:
solid copper RG59 or RG6 for video
and 18 AWG two-conductor for power.
Note:
Cable runs over 300ft may need larger than 18 gauge
wire for power due to voltage drop.
SET SCREWS
12V DC Power
BNC Video
Output
1. Position the camera
mount at the desired
location and use the
provided screws to
attach the camera
base to the wall.
2. Using the DC plug
supplied, connect the
power supply jack to
12VDC and the BNC
Video Output to the
desired video line.
Note: Do not supply
voltage other than 12VDC.
3. Once the camera is
installed, check the
viewing angle.
4. Install the sun shade
to block direct sunlight
on the
lens.
TROUBLESHOOTING
If you have trouble operating the camera, first refer to the
following guidelines. If the problem persists, contact Technical
Support at 866.838.5052.
Nothing appears on the display:
• Check if the power for camera and monitor is ON.
• Check if the VIDEO cable is connected to the camera BNC
video output jack.
• Check if the VIDEO cable is connected to the monitor
VIDEO input jack.
Image appears dim on the display:
• Check the monitor contrast setting.
• Check the monitor brightness setting.
• Check the lens. If necessary, wipe with a soft, clean cloth.
• Check if the camera is facing towards a bright light. If so,
change the camera position.
• If a device exists between the camera and screen,
confirm
the signal accepted by the screen is 75 Ohm impedance.
Image appears blurry on the display
• Check the lens. If necessary, clean with a soft, clean cloth.
The camera is not working properly and the camera
housing is hot
• Make sure the camera is connected to the correct power
source.
140219-1100
6.57”
2.89”
2.95”
DIMENSIONS
