TextAlert
IV
User Manual
9.2
Changing Recipients Cell Phone Numbers
This can be done, by overwriting the existing numbers using the same commands as in
Table 2. To erase a number completely, just send a blank space in place of the phone
number (e.g. 123456#10##).
9.3
Set up of Wireless Zone Type and Message
Each of the 16 wireless zones can be configured for armed / disarmed status and the
message to send when triggered using an SMS command.
The default message for each zone will be “Wireless activated (##) (Time, Date)”, where
(##) is the particular zone and (Time, Date) is the time and Date when activation took
place.
Sending
123456#50#1#New Message#
will set the text message for Zone 00 to "New
Message". TextAlert
IV
will then send confirmation that message has been changed, if the
reconfiguration notification feature is enabled.
e.g. Send – 123456#50#1#Intruder in garage#
Where,
•
123456
is the default password,
•
#
is used as a separator between configuration information,
•
50
represents zone (00)
, (51
would therefore represent zone (01)
,………..
and
65
zone (15)
,
•
1
is used to set zone is enabled (i.e. if zone is triggered then TA
IV
will alarm),
0
is
used to set zone is disabled (i.e. if zone is trigger then TA
IV
will not alarm, even if it
is armed),
2
is used to set zone for timed auto arming / disarming (TA
IV
will only
alarm if zone is triggered during the preset armed window (The auto arming time
can be set as per command in section 9.7),
•
and message to send is “
Intruder in garage
”.
9.4
Set up of Wired Zone Type and Message
Each of the 5 wired zones can be configured using an SMS command for armed /
disarmed status, the message to send when triggered and the status of the terminals – i.e.
Normally Closed vs Normally Open.
Use the same SMS command layout as for the wireless zones above, only the zone
numbers (xx) are from 66 to 70 and you need to include whether the wired terminal zone
must send an SMS when triggered or not.
e.g. 123456#65#1#Door contact triggered#1# will set wired zone 1 to active when armed,
with message “Door contact triggered” and terminal is to send an SMS when triggered. For
triggering the zone without sending an SMS use 123456#1#Door contact triggered#0#.
9.5
Setting PANIC Message to Send
Once you have programmed a remote onto TA
IV
, you can then customise the Panic
message for the remote by using the same method as for setting the wireless zone
message above. To do this, trigger the panic button and then take note of the default zone
number (##) in the default message received. Change the Message for this particular zone
to the Panic message that you require using the procedure above in section 9.4.
Copyright InFocus Trading 111 cc, 2009
14
