5
4. OPERATION:
LED Status Indicators
The LED status indicators on both the transceiver and the receiver units display its
current status or mode.Below, each status is described:
1. POWER LED: When lit, the power is connected.
2. DMX LED:
Transceiver Only:
• LED off: The unit is ready for you to choose the mode.
• Flashing every 1.5 seconds: Transmission is off.
• Flash every 1 seconds: Transmitting, but there is no DMX signal.
• Flash every 0.2 seconds: Searching for a receiver.
• On: Transmitting a DMX signal.
Receiver Only:
• Off: Not receiving.
• Flash every 1s: Receiving, but no DMX signal.
• Flash every 0.2s: Searching for transceiver.
• On: Receiving DMX signal. Receiver
3. MODE LED:
• Off: Wireless Mode 1 (Frequency 1)
• Flash: Wireless Mode 2 (Frequency 2)
• On: Wireless Mode 3 (Frequency 3)
Setting Up W-BRIDGE Wireless unit
1. One transceiver with multiple receivers:
Power on all units. The DMX LED indicators on all units should be off (if some DMX LED
indicators are on or are flashing, press & hold the
<FUNCTION> button until they turn off), then press the transceivers
<FUNCTION> button again. All the receivers should flash quickly, and then all be
matched up correctly.
2. Multiple transceivers, multiple receivers; e.g. 3 groups consisting of a
transceiver & receiver(s) named A,B, and C:
1.) Turn power off of all units.
2.) Group “A” gets powered on, then follow step 1 above.
3.) Group “B” gets powered on, then follow step 1 above.
4.) Group “C” gets powered on, then follow step 1 above.
