1.
BLADE ALIGNMENT
a)
Your clippers were carefully examined to unsure that
the blades were oiled and
aligned before leaving our
factory.
b)
Blades must be realigned
if
they
have
been
removed for cleaning or replacement.
c)
To realign the blades, simply match
the upper and bottom blades teeth
up, point for point. (End of top blade
teeth should be approximately
1.2mm back from bottom blade.
Compare your clipper blades with the
sketch.)
2.
OIL
a)
To maintain your clipper in peak
condition, the blades should be oiled
every few haircuts.
b)
Do not use hair oil, grease, oil mixed
with kerosene or any solvent.
c)
As the solvent will evaporate and
leave the thick oil which may slow
down the blades motion.
3.
BLADE LEVER
a)
The lever is conveniently located near your thumb (if
you’re right-handed) so it can easily be adjusted
while the clipper is in your hand.
b)
The Lever adds versatility to the Clipper by allowing a
gradual change to the closeness of a cut without an
attachment comb.
c)
When the Lever is in the uppermost position, the
Blades will give the closest cut leaving the hair very
FUNCTION INSTRUCTION
