AMP-plug connector
Power supply
230V~/50Hz
12VDC/30watts
mains
IEW EN 61347-2 -13
Stand : 02_2016
Mont_Alustar_U_engl
Art.Nr.: 51_030_003_0574
Installation Instructions
ALUSTAR U console-mount LED panel
goes on cupboard, showcase, shelf boards, etc. voltage: 12 VDC
before commencing installation, have in mind: wattage: 5 W approx.
- only use LED power supplies IAW EN 61347-2-13
Installation work is limited to skilled personnel in compliance with local or national regulations !
INSTALLATION
:
Secure LED lamp in place with screws from hardware bag.
Route connecting cable straight, do not damage insulating sheath.
Branch lamp with power supply module either direct, or using the 1.5 m extension from the hardware kit.
Beware of sharp edges, danger of cuts !
connecting cable
length = 0.3 m
to LED power supply
module to EN 61347-2-13
LED module in these lamps cannot be replaced.
Use is limited to dry, closed locations.
Do not use beyond the scope of proper use !
CAUTION !
Do not extend or damage original cables (both, lamps connection cables and power supply module power cord).
If cables need to be modified or replaced, such work is limited to skilled personnel using genuine cables and
complying with local regulations !
Install as shown (dissipation of heat) !
To avoid damage to your lamp's surface, never use solvents, abrasives are abrasive sponges for cleaning.
Clean with soft, damp cloth only (conventional dishwashing agents recommended); do not use solvents or alcohol!
subject to change without notice
Installation Instructions
ALUSTAR U console-mount console-mount LED overhead panel
kits of 2 ea.,3 ea., 4 ea., or 5 ea. lamps
SV2.5 junction box for 6 ea. lamps max.
CAUTION !
- installation work is limited to skilled personnel
- disconnect from mains before commencing work !
- comply with current regulations !
Do not extend or damage original cables (both, lamps connection cables and power supply
module power cord). If cables need to be modified or replaced, such work is limited to skilled
personnel using genuine cables and complying with local regulations !
Beware of sharp edges, danger of cuts !
Installation:
Branch LED lamps with junction box either direct or by using the 1.5 m extensions from the
hardware kit. Connect junction box with power supply module and plug power supply module in
standard wall outlet.
CAUTION: do not overload power supply module.
Allersberger Str. 52 - 54
90596 Schwanstetten
Tel. (0 91 70) 2 87 - 0
Fax (0 91 70) 2 87 - 99
Sensor-LED, only by
Master-lamp
0,3m
0,3m
0,3m
1,5 m
1,5 m
1,5 m
0,2 m
1,5m
Masterlamp
when connecting plug with
junction box make sure plug
is locked in place properly.
If not, try to resqueeze
until locked !
switchcable
