19
EN
DE
FR
+44 (0)20 78941516
www.topregal.com
WIPEKET
CHANGING THE SIDE BRUSHES
The main function of the side brushes is to pick up and transport trash from both sides to the center of the machine so that
it can be picked up by the main brush. The advantage of the side brushes is that they can sweep even the garbage out of
corners, thus increasing the cleaning area.
1. Ride up the side brushes.
2. Loosen the 4 nuts on the side brush from below to remove it.
3. Now you can replace the side brush.
ADJUST THE HEIGHT OF THE SIDE BRUSHES
1. Stop the rotating movement of the brushes.
2. Screw up the distance screw, to raise the brush.
3. Screw down the distance screw to lower the brush.
4. Then drive the brush up again, by tilting the brush knob in the other direction.
Adjust the height of the side brush if it is hung too low or too high to improve cleaning results and reduce brush wear.
CLEANING THE DUST FILTER
1. Open the upper housing.
2. Remove the cables and then the connections from the mechanics to the housing.
3. Close the housing again and loosen the screws of the hinges to replace the housing.
4. Loosen the 8 screws on the back of the motor box.
5. Pull the filter out of the box.
6. Knock out the dust filter. If it is particularly dirty, use a vacuum to suck off the surface of the filter.
7. Proceed in reverse order to reinsert the filter.
REPLACING THE BATTERIES
1. Open the housing.
2. Disconnect the negative (-) battery cable and then the positive (+) before disassembling the battery.
3. Avoid direct contact between the positive and negative terminals as this can cause a current short and
possibly cause a fire.
When reconnecting, make sure that the electrodes are properly connected, as incorrect connection may damage the
electrical components.
CHECKING THE SIDE SPLASH GUARD
1. Switch off the machine and place it on level ground.
2. Open the left and right guard plate of the machine.
3. Check the splash guard. If there are cracks or severe damage, replace the side splash guard.
4. Check that the height between the splash guard and the ground is between 0 and 3 mm.
Adjust the height if this figure differs.
5. Reassemble the unit in reverse order.
