06
07
feeling for more
feeling for more
Mode 2: Use the long gun ( Note: Connect the long rod with the short rod first, then
align the projection with the groove of the spray gun).
2) Install multi-function nozzles ( Note: After the nozzles are installed, shake the nozzles
left and right to check whether they are installed in place. In the shutdown state, the
nozzle can rotate 180 degrees to the left and right to form a straight line and a fan
shape, the nozzle must be upturn. )
3) Water pipe connection: insert the water inlet quick connector into the
corresponding position of the spray gun interface. After hearing the "click" sound, it
is firmly connected. When used for the first time, it is necessary to discharge the air
from the water pipe. Lower suction head is better, water flow out faster.
4) Two - speed model: select water pressure ( the washer has two water pressure
modes, H high pressure mode: used for cleaning stubborn dirt; L low pressure
mode, used to clean dirt that is easier to clean).
5) After the water outlet pipe is removed, the remaining water inside the water pipe
shall be cleaned first then put into the internal toolbox.
3.2.3 Installation Diagram
Insert gun rod into gun barrel
Rotate gun rod to fit into the groove
Water inlet pipe installation diagram
Water inlet connector
Quick connector
Water inlet pipe
Bucket
1m
Battery pack
installation diagram
100%
0%
2
2'
1
20V
4. Maintenance
Remove the battery pack from the spray gun before maintenance.
1) Before maintenance, please check whether the spray gun and parts are damaged. If
any damage is found, please stop using the spray gun and contact the supplier or
manufacturer to replace the parts.
2) Clean the water inlet filter regularly to avoid blockage affecting water inlet.
Problem Cause Action Remarks
Spray gun
can’s start
1. The battery has no power
2. The ambient
temperature is below 0
℃
3. Water absorption is not
smooth
1. Check the power supply
and charge it in time
2. Increase ambient temperature
3. Reduce the suction
5
.
Troubleshooting
Pressure is
not enough
1. There is air in the water pipe
2. The water inlet is blocked
3. There is impurities inside
1. Remove the gun rod and
work for a few seconds to
release air
2. Clean the water inlet filter
3.Remove internal impurities
Water leakage
1.The connection not tight
enough
2.O-ring damaged
1.Check the connection and tight
2.Change the O-ring
Running with
noise
1. Air sucking inside
2. Inner parts damaged
1. Check the water level and
inlet pipe
2. Repair spray gun and change
the parts