Wintriss wpc 2000, User Manual

Page: 141 / 250

1128500 WPC 2000 User Manual
3-50 Initialization, Setup, and Checkout
2.
Press and hold down both Run/Inch palm buttons until the press completes a stroke and
for ten seconds after the press stops.
•
If the press makes one stroke and then top-stops, WPC 2000 is operating correctly. Go
to the next applicable test.
•
If the press cycles again after making one stroke, check the wiring of the Operator
Station and correct any problems; then, repeat the test. If the press still cycles after it
makes one stroke, call Wintriss Tech. Support.
Continuous Mode Test with Light Curtain(s)
This test verifies that your press and the light curtains connected to it operate correctly in
Continuous mode. To verify Continuous mode operation on a press without light curtains, go
to the next test (page 3-52). If your press does not run in Continuous mode, go to the next
applicable test. To run the Continuous mode test with light curtains, do the following,
referring to Figure 3-14, Figure 3-15, or Figure 3-16 for LED locations:
1.
Set the Stroke Select switch to “CONT.” Verify that the “Continuous stroke select” LED
on the WPC 2000 Main Processor board is lit.
2.
Verify that the light curtain is unobstructed and that the “Light curtain A1 input” and
“Light curtain A2 input” LEDs on the WPC 2000 Main Processor board are lit. (If you are
testing a second pair of light curtains, verify that “Light curtain B1 input” and “Light
curtain B2 input” LEDs are lit.) These LEDs turn off when the light curtain is obstructed.
3.
Press the Prior Act button on the Operator Station. The Prior Act lamp should illuminate,
then turn off after eight seconds.
•
If the Prior Act lamp turns off after eight seconds, go to step 4.
•
If the Prior Act lamp does not turn off after eight seconds, stop! Do not go any further!
Call Wintriss Tech. Support.
IMPROPER SAFEGUARDING
• Install safeguarding devices as needed to ensure operator safety. Follow the machine guarding
requirements of OSHA regulation 1910.217 and any other regulations and standards that apply.
• Ensure that guarding is properly installed to prevent access to the machine over, under or
around any guarding device.
Failure to comply with these instructions will result in death or serious injury.
INJURY DURING TESTING
• Keep all personnel away from the press during testing.
• Be sure there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!