Wintriss wpc 2000, User Manual

Page: 130 / 250

WPC 2000 User Manual 1128500
Initialization, Setup, and Checkout 3-39
Checking the Emergency-stop Circuit
To check the Emergency-stop circuit, do the following:
1.
Run the press in Continuous mode, and press the Emergency Stop button on the Operator
Station. The press should Emergency-stop immediately.
Figure 3-16. WPC 2000 Display Board LED Indicator Map
CHECKING THE EMERGENCY-STOP CIRCUIT IN SINGLE STROKE MODE
If your press does not run in Continuous mode, run this test while the press is making a stroke in
Single-stroke mode.
T
B
7
0
3
151 - Automatic single-stroke select
T
B
7
0
2
149 - One-hand control select
148 - Foot control select
147 - Spare
T
B
7
0
1
143 - Single stroke select
142 - Continuous stroke select
145 - Off stroke select
144 - Inch stroke select
T
B
7
0
4
154 - Operator station 1 select
153 - Operator station 2 select
157 - Micro-inch select
156 - Set auxiliary cams select
T
B
7
0
5
Display cable transmit
Display cable receive
T
B
7
0
6
J 707
WPC Settings key switch up (+) Spare
Reset/Select button on WPC Settings key switch down (-)
All LEDs are red except the “Display cable
receive” LED, which is yellow. Pin numbers
associated with LEDs are shown in bold .
LED positions on board are represented
schematically.
NOTICE