Wintriss WPC 1000, User Manual

Page: 62 / 235

WPC 1000 User Manual 1125100
Installation 2-35
1.
Select a convenient location for mounting the cam output assembly, choosing one that
allows you to easily run conduit from WPC 1000 to the cam outputs. You do not need to
access the cam outputs once they are installed and wired.
2.
Mount the cam output assembly, referring to Figure 2-17, below, or Figure 2-18,
page 2-36 for mounting dimensions. Use the holes on the flanges to mount the cam output
enclosure or the corner holes to mount the cam output board.
3.
The relays that will control your equipment should already be plugged into the cam output
board. If you need to replace a relay, simply pull the device out of its socket. Before
installing a relay, make sure that all the pins match the socket holes so you do not bend the
pins; then, press the relay in firmly.
4.
Locate the twelve-conductor shielded cable that connects the WPC 1000 Control board to
the cam outputs, and terminate the shield at each end near the entry point to the enclosure
or console (see Terminating Cable Shields, page 2-5).
5.
Remove the TB101 and TB102 connectors from the WPC 1000 Control board, and attach
the wires at one end of the cable to the terminals shown in Table 2-9, page 2-36 and Figure
2 at the end of the manual. Plug each connector back into its socket when you are
finished.
Figure 2-17. Cam Output Enclosure: Mounting Dimensions
4.00
(101.6)
5.41
(137.4)
6.62
(168.1)
7.38
(187.5)
Dimensions: inches
(mm)
3.48
(88.4)