Wintriss WPC 1000, User Manual

Page: 145 / 235

1125100 WPC 1000 User Manual
3-46 Initialization, Setup, and Checkout
3.
Remove both hands from the Run/Inch buttons.
4.
Press and hold down both Run/Inch buttons to cycle the press through one stroke. When
the press top-stops, continue to hold down the right button, and remove your hand from
the left button; then, after a moment, replace your hand on the left button and continue to
hold down both buttons.
•
If the press does not initiate the stroke, the test has been completed successfully. Go to
the next applicable test.
•
If the press does initiate the stroke, check the wiring of the palm buttons, correcting any
problems, then repeat step 4. If the press still initiates the stroke, call Wintriss Tech.
Support.
Anti-repeat Test
The anti-repeat test verifies that the press cycles only once when WPC 1000 is in
Single-stroke mode and both Run/Inch buttons are pressed simultaneously. To perform the
test, do the following:
1.
Set the Stroke Select switch to “SINGLE.”
2.
Press and hold down both Run/Inch palm buttons until the press completes a stroke and
for ten seconds after the press stops.
•
If the press makes one stroke and then top-stops, WPC 1000 is operating correctly. Go
to the next applicable test.
•
If the press cycles again after making one stroke, check the wiring of the Operator
Station and correct any problems; then, repeat the test. If the press still cycles after it
makes one stroke, call Wintriss Tech. Support.
INJURY DURING TESTING
• Keep all personnel away from the press during testing.
• Be sure there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
OPERATOR STATION MAY NOT MEET SAFETY REQUIREMENTS
Ensure that the Operator Station is wired correctly.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!