Wintriss SmartPAC PRO Servo, User Manual

Page: 53 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 2
– Installation
53
Table 2-8. ProCamPAC Linear to Cam Output Assembly TB301 Wiring, Cams 9-15
Wire ProCamPAC Linear
TB452 (Pin #)
2nd Cam Output Board
TB301 (Pin #)
CHAS (1)
White Relay Pwr (281) A (3)*
Black Gnd (280) B (2)*
Red +5 (279) +5 Vdc (4)
Unused Unused
Pink Ch 15 (277) Ch 7 (6)
Gray Ch 14 (276) Ch 6 (7)
Blue Ch 13 (275) Ch 5 (8)
Yellow Ch 12 (274) Ch 4 (9)
Orange Ch 11 (273) Ch 3 (10)
Purple Ch 10 (272) Ch 2 (11)
Brown Ch 9 (271) Ch 1 (12)
* Note that the pin numbers for A and B are out of order
8. Remove the TB301 connector from its socket, and connect wires from the 12-conductor
cable(s) as shown in Table 2-7(for 8-channel ProCamPAC Linear) or Table 2-7 and Table 2-8
(for a 15-channel ProCamPAC Linear). A wire from CHAS to a lug on the ProCamPAC
Output enclosure should already be connected (unless you bought the board assembly only).
9. Plug the connector(s) back into its socket.
10. To connect the relays to your equipment, use connectors TB302 and TB303 (Figure 2-16).
Figure 2-16. TB302 and TB 303 for Wiring Relays to Equipment
Specific connections depend on the type of relay you use. For 120 Vac relays, you can connect
wires from your equipment to “C” and either the N/O or N/C side of the relay. If you connect to
N/O, the equipment will be on for the number of degrees set in SmartPAC PRO Servo. If you
connect to N/C, the equipment will be on except for the number degrees set. Generally, you
should use the N/O terminal so that equipment is off except when you use SmartPAC PRO Servo
to turn it on. Use the N/C terminal only if it is more practical to do the reverse.
All solid state relays work only when the C and the N/O terminals are connected. Polarity must be
correct for DC solid state relays (refer to Table 2-9.)