Wintriss SmartPAC PRO Servo, User Manual

Page: 33 / 228

SmartPAC PRO Servo User Manual 1147100
Chapter 2
– Installation
33
Installing SmartPAC PRO Servo as a Panel Mount
If you have received the panel-mount configuration of SmartPAC PRO Servo, follow the steps below
to install the panel mount in your enclosure. The panel mount is usually installed from the outside of
the enclosure. Be sure to allow at least 6 in. (152 mm) of clearance behind the panel mounting plane
to leave enough room for the electronics.
1. Determine a convenient location within your enclosure or console for mounting SmartPAC PRO
Servo. Ideally, SmartPAC PRO Servo should be mounted where operators and setup personnel
can easily see the readouts and reach the keyboard.
2. Cut out a hole in your enclosure, and drill and tap twelve holes for #10-32 screws, referring to
Figure 2-3 and Figure 2-4, below for cutout and mounting dimensions.
3. Prop the panel mount near the cutout location. You can do this by connecting ty wraps from two
of the left holes on the panel to the corresponding holes on the enclosure or console, creating
hinges.
4. Perform wiring connections as shown in the following sections. Make sure all cables will reach
the connectors on the back of the panel mount.
5. When final checkout procedures have been completed (see Final Checkout , page 58), install the
panel mount in your enclosure or console, using twelve #10-32 screws.
Figure 2-3. SmartPAC PRO Servo Panel Mount Cutout Dimensions