Wintriss SmartPAC PRO Servo, User Manual

Page: 148 / 228

1147100 SmartPAC PRO Servo User Manual
148 Chapter 5
– Program Mode
5. If you want to adjust On/Off settings for a previously programmed arc, press SELECT ARC one
or more times until the highlighting for that arc turns green, then use the cursor keys to change
the On and/or Off angles.
NOTICE
To delete an On/Off arc for a multi-arc cam channel, you must delete all settings for the channel
(see page 5-46) and program the On/Off outputs again.
6. Press RESET when you have finished to return to the Cam Channel Program Type Menu.
Making a Timed Output Setting
NOTICE
MAXIMUM NUMBER OF TIMED CHANNELS PER TOOL
Each tool can have up to four Timed Output cam channels.
The PROGRAM TIMED OUTPUT item on the Cam Channel Program Type Menu enables you to
program the ram angle and position at which a selected cam channel turns On and the time, or dwell,
in milliseconds that the channel stays On.
A Timed Output setting is independent of press speed–with On/Off cam outputs, the On time
decreases with press speed–and is recommended for functions such as controlling air and lubrication.
This type of cam output also ensures that the channel will turn off after the programmed time. With
On/Off cam settings, the channel stays on if the press stops within the On/Off window, potentially
wasting air or lube.
To set a Timed Output for a cam, do the following:
1. Select PROGRAM TIMED OUTPUT on the Cam Channel Program Type Menu. The Cam
Channel Timed Output Program screen displays, Figure 5-51.
Figure 5-51. Cam Channel Timed Output Program Screen
2. Set the On angle on the ram angle clock, using the Left (

) and Right (

) cursor keys. As you
press the Left (

) cursor key, the On cursor moves counterclockwise around the display, and the
Cam ON ram position
Cam ON angle
Cam ON duration