Wintriss SmartPAC 2, User Manual

Page: 377 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Fault Messages 7-15
* Stop types for all inputs except input pair 10/11 are set to E-Stop by default; input pair 10/11
is set to E-Stop/Lockout. All inputs except input pair 10/11 can be reconfigured by the user.
If you have SmartPAC 2 firmware version 3.32 or higher and WPC 2000 firmware version
1.70 or higher, an additional stop type option, Top-stop/Lockout, is available for user inputs
1-7. To set these inputs to Top-stop/Lockout or to change the stop type setting for any user
input, see page 4-24.
Problem
: A failure has occurred in an auxiliary press function wired to WPC 2000
cross-checked input pair 10 and 11 (see Table 7-2). One or both inputs are open.
Remedy
: Diagnose and correct the condition that the inputs are monitoring. If the error
persists after you reset the unit, contact Wintriss Tech. Support.
Problem
: A failure has occurred in an auxiliary press function wired to WPC 2000
cross-checked input pair 8 and 9 (see Table 7-2). One or both inputs are open.
Remedy
: Diagnose and correct the condition that the inputs are monitoring. If the error
persists after you reset the unit, contact Wintriss Tech. Support.
Table 7-2. Fault Codes for User Inputs
Fault Code
User Input
(Interlock) Stop Type * Pin #
Jumper
Connection
(Bypass)
51 User 1 21 +24 Vdc
52 User 2 82 +24 Vdc
53 User 3 71 +24 Vdc
54 User 4 83 Ground
55 User 5 72 Ground
56 User 6 84 Ground
57 User 7 73 Ground
58, 17
User 8 paired
with 9
85 Ground
User 9 paired
with 8
74 Ground
50, 18
User 10 paired
with 11
E-stop/
Lockout
86 Ground
User 11 paired
with 10
18 Ground
F50
F58