Wintriss SmartPAC 2, User Manual

Page: 294 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
5-40 Program Mode
Instructions for programming cam channels, using each of the program types shown on
the Cam Channel Program Type Menu, are provided in the following sections.
Making an ON/OFF Setting
The PROGRAM ON/OFF ANGLES item on the Cam Channel Program Type Menu enables
you to program the crankshaft angles at which a selected cam channel turns on and off. You
can program up to four on/off sequences per stroke. To make a single on/off setting for a
selected cam channel, perform the following steps (to make multiple on/off settings, see
Setting Multiple ON/OFF Cycles
, page 5-41):
1.
Select PROGRAM ON/OFF ANGLES on the Cam Channel Program Type Menu. The
Cam Channel On/Off Program screen, shown in Figure 5-46, displays.
2.
Set the On angle on the crank angle clock, using the Left (

) and Right (

) cursor keys.
Refer to
Using Cursor Keys to Set Timing
, page 3-7 if you need help.
As you press the Left (

) cursor key, the On cursor moves counterclockwise around the
display, and the On angle value decreases. When you press the Right (

) cursor key, the
On cursor moves clockwise around the display, and the On angle value increases.
The precise On angle value is displayed in the window inside the clock display.
3.
Set the Off angle on the crank angle clock, using the Up (

) and Down (

) cursor keys.
As you press the Up (

) cursor key, the Off cursor moves clockwise around the display,
and the Off angle increases. As you press the Down (

) cursor key, the Off cursor moves
counterclockwise around the display, and the Off angle decreases.
The precise Off angle value is displayed in the window inside the clock display.
4.
Press RESET when you are finished to return to the Cam Channel Program Type Menu.
Figure 5-46. Cam Channel On/Off Program Screen
Highlighted arc
shows “dwell”
of cam On signal
Cam On and Off
angles
F1
F2
F3
F4
F5
F6
F7
F8