Wintriss SmartPAC 2, User Manual

Page: 220 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
4-34 Initialization Mode
Initializing WPC 2000 Parameters
When you first set up your SmartPAC 2 with WPC 2000 or when you install new WPC 2000
firmware, initialize WPC 2000 parameters by following the steps below. If you install new
WPC 2000 firmware in an existing system, first record press parameters so you can re-enter
them after initializing the system.
1.
On the Press Control Parameter Menu, move the highlight bar to the INITIALIZE
PARAMETERS item, and press ENTER. The message shown in Figure 4-22 displays.
2.
Press ENTER to continue the Initialize Parameters process
or
Press RESET to cancel the Initialize Parameters process.
The warning message disappears, and you are returned to the Press Control Parameter
Menu.
INITIALIZE WPC 2000 PARAMETERS BEFORE PROGRAMMING SMARTPAC 2/WPC 2000
When you set up a new SmartPAC 2 with WPC 2000, initialize WPC 2000 press parameters
before you start programming your unit. See page 2-75.
RECORD WPC 2000 SETTINGS BEFORE INITIALIZING PARAMETERS
Use the Press Parameters Setup Sheet at the end of the manual to record your WPC 2000
settings before installing new firmware or initializing parameters.
Initializing press parameters resets WPC 2000 to its default settings. Initialize WPC 2000
parameters only when you set up a new SmartPAC 2 with WPC 2000 or install new WPC 2000
firmware.
Figure 4-22. Initialize Parameters Warning Message
NOTICE
NOTICE
NOTICE