Wintriss SmartPAC 2, User Manual

Page: 153 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Installation 2-109
4.
Depress the Foot Switch and immediately release it. The press should make a single
stroke and stop at top dead center.
Verify that the “FOOT N/O” item on the WPC Buttons and Switches Input Status screen
(see Figure 4-26, page 4-45) changes from an OFF to an ON status and that the “FOOT
N/C” item changes from ON to OFF.
•
If the press strokes and the status of the inputs is correct, go to the next step.
•
If the press does not stroke or the inputs are not in the correct state, check the wiring of
the Foot Switch, the setting of switch 3 (it should be OPEN), and the selection on the
Mode Select Menu (FOOT should be selected). Make any necessary corrections, and
repeat step 4. If the press still does not stroke, call Wintriss Tech. Support.
5.
Set option switch 3 to CLOSED.
6.
Power down, then power back up WPC 2000 to enable the settings change. You are now
in Foot Control mode. The press should cycle to Top-stop only if the Foot Switch is held
down past the Auto Carry-up Angle.
7.
Press and hold the Foot Switch through the Auto Carry-up Angle, then release the Foot
Switch. The press should complete the stroke, stopping at Top-stop.
•
If the press completes the stroke, go to the next step.
•
If the press does not complete the stroke, check the wiring of the Foot Switch and the
setting of switch 3 (it should be CLOSED). Make any necessary corrections, and repeat
step 7. If the press still does not stroke, call Wintriss Tech. Support.
8.
Press and hold the Foot Switch again, but release it before the Auto Carry-up Angle. The
press should begin to cycle but stop immediately when the Foot Switch is released.
•
If the press stops, go to the next step.
•
If the press does not stop, check the wiring of the Foot Switch, making any necessary
corrections, and repeat step 8. If the press still does not stop, call Wintriss Tech.
Support.
9.
Press and hold both Run/Inch buttons to return the press to TDC.
10.
Set the Stroke Select switch to “CONT.” Verify that the “CONT SEL” item on the WPC
Buttons and Switches Input Status screen shows an ON status (see Figure 4-26,
page 4-45).
Depress the Foot Switch quickly and fully to initiate a stroke. If you depress the Foot
Switch slowly or partially, the press will not stroke.
If the Interrupted Stroke message displays, you must depress and hold the Run/Inch
buttons on the Operator Station to bring the press back to top dead center and clear the
Interrupted Stroke before you can operate the Foot Switch.
NOTICE
NOTICE