Wintriss SmartPAC 2, User Manual

Page: 143 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Installation 2-99
If the applicable terminal does not read 0 V relative to ground, check and correct the
ground wiring for the unit.
The Light Curtain Test Mode jumper (JP124 for Light Curtain 1, JP122 for Light
Curtain 2–see Figure 2-14, page 2-28 for location on the WPC 2000 Main Processor
board), should be positioned at the “INT” setting when Shadow VII, Shadow 8, or
Shadow 9 light curtains are installed. Reposition the jumper to the correct setting if
necessary. The Light Curtain Output Type jumper (JP123 for Light Curtain 1, JP121 for
Light Curtain 2) should be set to “PNP.”
If the red indicator is still illuminated, call Wintriss Tech. Support.
•
If both the receiver’s green and red indicators are unlit, power down the unit and check
the wiring to the receiver. Also check the power fuse (located in the Shadow V receiver,
in the Shadow VI, Shadow VII, Shadow 8, or Shadow 9 (optional) control box, not
present in the Shadow VII DIN control), and replace if necessary. Power up again. If
the receiver’s green and red indicators are still off, replace them. If none of these
remedies corrects the problem, call Wintriss Tech. Support.
4.
Block the light curtain. On the receiver, the green indicator should turn off and the red
indicator should illuminate.
•
If the receiver’s green indicator goes off and the red indicator comes on, go to the next
step.
•
If the receiver’s green indicator stays on when the curtain is blocked, check receiver
wiring, and repeat step 4. If the green indicator is still lit, call Wintriss Tech. Support.
5.
Remove the obstruction from the light curtain. At the receiver, verify that the red
indicator goes off and the green indicator comes on.
6.
Go to the next applicable test.
Single-stroke Mode Test with Light Curtain(s)
INJURY DURING TESTING
• Keep all personnel away from the press during testing.
• Be sure there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
CONTINUOUS MODE USED ON PRESS NOT GUARDED PROPERLY FOR CONTINUOUS
Disconnect the “Continuous” position on the Stroke Select switch to prevent your press from being
run in Continuous mode if it is not guarded correctly for use in Continuous mode. Also cover the
“CONT” label on your control’s Stroke Select switch.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!