Wintriss Shadow 8, User Manual

Page: 70 / 159

Shadow 8 User Manual 1139300
Installation and Checkout 2-45
Setting Option Switches
The DIP switches on Main Receiver and Transmitter (shown in their factory default positions
in Figure 2-24, page 2-46) allow you to set the following options:
•
Operating Mode: Automatic Start or Start/Restart Interlock
•
External Device Monitoring (EDM): Disable/Enable
•
Scan Code: A or B
•
Floating Blanking: Disable/Enable
•
Programmable Fixed Blanking: Disable/Enable
•
Scanning Range: Short/Long
Receiver switches are organized in two blocks, SWA (upper block) and SWB (lower block).
With the exception of switch 6, both SWA and SWB switches must be set to the same position
(i.e., OFF or ON) for each option. Otherwise, Shadow 8 generates a “23” fault code on the
IBIs on the Main Receiver (see page 4-2).
OPTION SWITCH ACCESS DOOR MUST BE SCREWED SHUT DURING MACHINE OPERATION
Make sure that option switch access doors on both Main Receiver and Transmitter are screwed
shut during operation of the guarded machine. Failure to secure access doors during machine
operation can result in oil penetration of the optic heads and will void the light curtain warranty.
Failure to comply with these instructions may result in property damage.
USE SCREWDRIVER OF CORRECT SIZE TO SCREW DOWN OPTION SWITCH ACCESS DOORS
Use a Phillips screwdriver of the correct size to screw down the option switch access doors. Use of
too small or too large a screwdriver may damage the screw heads.
Failure to comply with these instructions may result in property damage.
USE SLENDER BLUNT TOOL TO SET OPTION SWITCHES
When setting the option switches to the OFF or ON position, use a tool that is both slender enough
to engage an individual switch yet blunt enough not to damage the switch.
Failure to comply with these instructions may result in property damage.
CAUTION
CAUTION
CAUTION