Wintriss autoset 1500, User Manual

Page: 57 / 102

AutoSet User Manual 1137200
Calibration 3-9
example, as illustrated in Figure 3-4, you would turn the “100s” indicator to “2,” and turn
the “10s” and “1s” indicators to “0.”
8.
Set the three Tonnage dial indicators to twice the full-scale tonnage of one load cell.
For tonnages greater than 999 (i.e., with more than three digits), set the dials to one-tenth
of the value you want. For example, to indicate a full-scale tonnage of 1200 tons, set the
dials to “120” (i.e., 120 x 10 = 1200).
AutoSet Load LED displays format tonnage readings based on two factors: the full-scale
tonnage you have specified on the dial indicators and the position of switch #3 on the
Mode switch block (S6 in Figure 3-2, S1 in Figure 3-3). Figure 3-5 shows the Mode
switch block on old-style AutoSet 1500 calibration kit processor boards. The switch block
on new-style boards uses slightly different labels.
When switch #3 is in the OPEN position, AutoSet LED displays include a decimal place.
When switch #3 is in the CLOSED position, no decimal point is shown. The decimal
point is not active for full-scale tonnage settings between 201 and 1500 tons. Table 3-2,
page 3-10 summarizes your tonnage display options.
Figure 3-4. Tonnage Dial Indicators: Old-style Board (Left), New-style Board (Right)
Even if you are using two load cells for calibration, you still set the Tonnage dial indicators
to twice the full-scale tonnage of one load cell.
Figure 3-5. Mode Switch #3 Set to “Decimal Point Off” Position (Old-style Processor Board)
1 2
8
7 6
5
4
9
3
0
1 2
8
7 6
5
4
9
3
0
S5
S1
TONNAGE
1s
100s
10s
S4
1 2
8
7 6
5
4
9
3
0
1 2
8
7 6
5
4
9
3
0
1 2
8
7 6
5
4
9
3
0
1 2
8
7 6
5
4
9
3
0
S5
S3
TONNAGE
100s
1s
10s
S4
NOTICE
S6
15 STROKES
ZERO CAM DISABLE
DECIMAL POINT ON
ON
1 STROKE
ZERO CAM ENABLE
DECIMAL POINT OFF
OFF
MODE SELECTOR