Wintriss autoset 1500, User Manual

Page: 39 / 102

AutoSet User Manual 1137200
Installation 2-19
7.
Plug the connector back into the TB101B or TB101A terminal block. The connector can
be plugged in only one way. Check the wiring connections to make sure they are correct.
8.
If you have a standard 1500 or 1504 AutoSet, locate the Mode switch block (S101) just to
the right of the ribbon cable connector on the left side of the AutoSet processor board (see
Figure 2-14, page 2-20).
Using a ballpoint pen or small screwdriver, move switch #2 to the ON, or right, position.
When switch #2 is set to ON, Zero Cam is enabled on standard AutoSet units. The Zero
Cam feature is always enabled on AutoSet Plus load analyzers.
9.
After you have connected AutoSet to a power source (see next section), turn the unit on
and, referring to the Zero Cam LED on the AutoSet front panel, check to make sure that
the zero signal comes on at approximately 240° and turns off at 30°. The zero signal is on
when the Zero Cam LED is illuminated.
Table 2-6. LMCS (Zero Cam) Wiring Connections, TB101B or TB101A
AutoSet Model Terminal Block Pin # Label Wire Color
1500 or 1500 Plus TB101B 2 Zero Cam White or clear
4 +12Vdc Red
5 Ground Black
1504 or 1504 Plus TB101A 2 Zero Cam White or clear
4 +12Vdc Red
10 Ground Black
WIRING FOR DEVICES OTHER THAN LMCS
Mechanical switches and programmable limit switches (PLS) do not require power
connections, so you will not need to make connections to pin 4 (+12 VDC). If your switch
does need power, however, make sure to wire the switch to pin 4 (+12 VDC) and either pin
5 (AutoSet 1500/1500 Plus) or pin 10 (1504/1504 Plus), which provides the Ground
connection.
The LMCS has no separate ground connection for the zero signal. The ground for power
and the ground for the signal are the same. Other switches requiring power may have
identical power and signal ground connections. Check the instructions for your switch.
If you have an AutoSet 1500 Plus or 1504 Plus, the Zero Cam feature is always enabled.
You do not have to set Mode switch #2 (see step 8).
NOTICE
NOTICE
NOTICE