Instructions condensing Air heaters type HR
Page 3/31
13
ELECTRICAL DIAGRAM
25
14
EXPLODED VIEWS AND SPARE PARTS
27
14.1
S
PARE PARTS
27
14.2
E
XPLODED VIEW
HR10-20
28
14.3
E
XPLODED VIEW
HR30-60
29
14.4
E
XPLODED VIEW
HR80-120
30
15
CE CERTIFICATE & DECLARATION
31
3
General
The premix unit air heater is provided with sophisticated control sequence to maintain a
comfortable room temperature and even air distribution.
It is paramount that that the installation and maintenance of this appliance are carried out by
qualified gas engineers, and strictly according to our instructions.
This is a condensing heater. This means a condensate water discharge system should be
installed according to local regulations. Never block this discharge.
3.1 Guarantee
The guarantee is invalidated when the air heaters are not installed in accordance with this
manual.
4
Application restrictions
Important!
The installation en maintenance of this air heater should be performed by an
authorized competent installer in accordance with this manual.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children may not play with this heater.
4.1 Pre-check
Before unpacking and installation, please check (i.e. on the data badge) if the heater is in
accordance with the order and if it is suitable for the local present provisions (gas type, gas
pressure, electrical supply etc.)
The Installation must comply with all applicable local and national standards.
The installation of the air heater must be in accordance with the relevant requirements of the
Gas Safety regulations (for example in GB; The Institute of Gas Engineers IGE UP-1 and 2),
building regulations and the IIE regulations also incorporating the gas safety (installation and
use) regulations. Other national and/or local regulations may apply (the Local Authority ,Fire
Officer and Insurers)
The competent installer must make sure the heater operates correctly and must instruct the
user about the safe operation of the heater.
A ventilation gap of 30 cm is required from the top and bottom of the heater to any flammable
materials.
If this heater is drawing its combustion air from within the room in where it is located, the
necessary combustion ventilation requirements must be followed for gas safety regulations.
The heater should not be installed in areas containing any corrosive or explosive vapours , in
high moisture or dust concentrations, at negative pressures or temperatures higher than 30°C ;
please consult Winterwarm or your supplier. The guarantee is then invalidated..
