Winterthur Gas X40-B, Maintenance Manual

Page: 230 / 495

Maintenance
3303 − 3/A1
Winterthur Gas & Diesel Ltd.
2/ 8
5) Attach the two eye bolts (EB, Fig. 2 ) to
the cylinder block (1).
6) Attach the two eye bolts (EB2) to the
guide shoes (2).
7) Attach the stop plate (94335) to the
bearing cover (4) with the screw.
8) Attach the manual ratchets (H1, H2) to
the eye bolts (EB, EB2).
9) Attach the tool (94337) to the connecting
rod (3).
10) Torque the screws (8) to 290 Nm.
11) Attach the support (94332) to the
column door and the tool (94337).
12) Operate the manual ratchets (H1, H2) to
lift the crosshead (3) sufficiently to install
the two supports (94322).
13) Attach the two supports (94322) to the
position shown on the column.
14) Torque the four screws (5) and the two
screws (6) to 150 Nm.
15) Operate carefully the manual ratchets
(H1, H2) to lower the crosshead (3)on to
the supports (94322).
16) Adjust the two screws (7) to get an equal
load.
2.1 Bearing Shell − Inspection
1) Do an inspection of the bearing shell (9).
2) If it is necessary to remove the bearing
shell, do step a ) and step b ).
a) Remove the two screws (10).
b) Remove the bearing shell (9).
10
9
10
2016
Top End Bearing − Removal, Inspection and Installation
Fig. 2
WCH00617
I
I
H2
EB
1
3
2
EB2
I - I
3
2
EB2
94335
4
II
II
H1
EB
WCH00617
H1
H2
IV
6 5
WCH00574
7
III
III
IV
94322
94337 94332
8
3
9