7
7.Maintenance
1.after working finish for each time,the machine need to be cleaned,but not use water.
2.the metal material such as glue part need to use alcohol clean, but not use other
chemical or it will change shape and affect the function of machine.
Every part stick on the glue is forbidden to use hand things to
scratch,avoidscathe the surface and affect the function of machine.
3. Up and down straight line bearings pole and hight adjust pole much regularly the
clean behind add lubrication oil.at the general workload case,each week about 1
times.
8.Troubleshooting
9. Inverter Parameter setting way
At the stop state,long press
“
MODE
”
key about 3 seconds,(the numerical tube at the
same times display
“
”
),when the numerical tube display
“
”
and at the
numerical replace mutual flashing,said explain already enter into common parameters
setting state.press the up key and down key change parameters,press
“
MODE
”
key
enter into next ,(at the not need change times,direct press
“
MODE
”
key enter into next
parameters.)when the parameters setting finish,the numerical tube display
“
”，
prompt whether save this time change,press
“
MODE
”
key save exit.
№
Malfunctions
Solutions
1
Electric light not
on,machine do notwork
a.check if the electric wire whether connected.
b.stop whether loose.
c.check if the control wire whether ruin.
2
Motor do not run
a.if the motor have voice,then the electric wire less one phease,connect it
；
b.check the motor whether load excessive ,cause plugging turn
；
c.other problem,find special worker.
3
At the trimming resistance
excessive shake obviously.
a.check the knife edge whether than more glue? If is glue than
more ,please clean glue
；
b.check the knife whether change blunt ,please grinding or changing tools
at the blunt
；
c.check motor base ,motor fixed nuts whether loose.
