MENU
F.Preparation for measurement
1. Install batteries;
Put batteries into battery compartment correctly,
paying attention to the polarity of battery.
Press “ ” button to turn on the meter, after powering on,
check battery status. If power is low, please replace
battery in time.
2. Select probe for measurement;
Based on measurement requirements,
users can select different probes. Measuring
with different probes may yield different
evaluations on measurement results.
a. Measure with short (S) probe:
This probe is installed randomly and
suitable for a wide range of vibration
measurements with better response values.
b. Measure with long (L) probe:
This probe is an accessory in the package
and is mainly used on narrow or special
objects with faster response.
c. Remove hardware probe
to measure: this way is for
measurement on flat object
surface with stable data.
6
1.Power on / off
Short press “ ”button to power on, long
press“ ”button to shut down.
2. Screen rotation
After powering on, press “ ” button to rotate screen.
Only acceleration measurement, speed measurement,
displacement measurement and full display interface support
screen rotation. Each rotation will clear cached data.
3. Full display measurement
Press “ ” to turn on the meter, full display interface
appears after powering on; short press“ ” to switch
between high frequency and low frequency mode. Long
press“ ”button or short press “ ” button to start
automatic measurement, short press again to exit
measurement. When cached data is over 0, press“ ”to
save and window prompt pops up to indicate successful
operation, then press “ ”button to OK storage.
(The cache can hold up to 20 data, and the first data will be
automatically removed if the cache is more than 20; the
maximum data storage is 7 groups, and there will be a
prompt when storage is full.)
MENU
MEAS
MEAS
MENU
MENU
SAVE
OK
LO/HI
OK
G.Operation instruction
7
52%
20Hz~1KHz
Mode:Lo Freq
12.8
2
m/s
30.2
mm/s
0.112
mm
Menu
52%
1 Hz~10KHz
K
Mode:Hi Freq
10.3
2
m/s
30.2
mm/s
0.112
mm
Menu
Short (S) probe
measurement
Long (L) probe
measurement
Remove hardware
probe measurement
Full display interface
(low frequency mode)
Full display interface
(high frequency mode)
