SBC35-427/BIOS Settings
v1.0
www.winsystems.com
Page 21
4.3.17 Debug
Control the Direct Connect Interface (DCI), which allows debugging using a
USB3 port.
4.3.18 Intel I210 Gigabit Network Connection 1 & 2
Configure the Intel I210 Network Interface Controller (NIC), and view
specific technical information such as link status, and MAC address.
Feature
Description
Choices
Default
DCI Enable
(HDCIEN)
Enables/disables Direct Connect Interface (DCI).
When DCI is enabled, it is taken as user consent to
enable DCI which allows debug over the USB3
interface. When disabled, the host control is not
enabling DCI feature.
Enable,
Disable
Disable
DCI Auto Detect
Enable
Enables/disables DCI Auto Detect. When set to Auto
Detect, it detects DCI being connected during BIOS
post time and enables DCI. Otherwise it disables
DCI.
Enable,
Disable
Enable
Feature
Description
Choices
Default
NIC
Configuration
Provides options to configure the link speed and enables/disables Wake on Lan.
•
Link Speed
Specifies the port speed used for the selected
boot protocol.
Auto
Negotiated,
10 Mbps Half,
10 Mbps Full,
100 Mbps Half,
100 Mbps Full
Auto
Negotiated
•
Wake On
LAN
Enables the server to be powered on using an in-
band magic packet.
Enable, Disable Disable
•
Blink LEDs
Specifies the number of seconds to blink LEDs.
This function provides the ability to physically
view which Ethernet NIC is #1 or #2. To blink the
integrated LEDs on the RJ45 connector, type a
number from 0 to 15 (seconds) then press
Enter
to blink the LEDs for that amount of time.
0-15 0
