PPC65BP-1x/Setup and Installation
v1.0
www.winsystems.com
Page 18
7.5
Connecting Power to J16
To connect power through the 3-pin terminal block:
1. Plug the 3-pin female terminal block to J16 securing with the two
captive screws.
2. Using the following the pin definition in the table below, install the
power supply wiring and secure with connector screw.
– Use AWG 22-14 wire
– Supply voltage between 12 V DC and 24 V DC
– Make connections according to the following table:
7.6
Connecting Components
The PPC65BP-1x provides edge connectors for common external
connections, and also internal connections to components on the board
(see “Touch Screen External Control, Connector, and Indicator Locations”
1. Connect an Ethernet cable to Gigabit Ethernet (connects to J13/J14, as
applicable).
Pin
Description
1
Ground (Earth)
2
Voltage in negative (Vin-)
3
Voltage in (Vin+)
3-pin terminal block
Summary of Contents for PPC65BP-1 Series
Page 59: ...PPC65BP 1x v1 0 www winsystems com Page 59 PPC65BP 12 Dimensions...
Page 60: ...PPC65BP 1x v1 0 www winsystems com Page 60 PPC65BP 15 Dimensions...
Page 61: ...PPC65BP 1x v1 0 www winsystems com Page 61 PPC65BP 17 Dimensions...
Page 62: ...PPC65BP 1x v1 0 www winsystems com Page 62 PPC65BP 19 Dimensions...