Installation
26
5. Remove the fastening plates and the hob
top.
Replacing nozzles
1. Unscrew screw
A
and push air regulator
B
as far as it will go.
2. Use a spanner to remove the nozzles
C
and install the new ones for the required
gas supply, following the indications
given in the relevant table.
3. Adjust the air flow by moving the air
regulator
B
to obtain the distance
D
given in the corresponding table.
4. After adjusting each burner, reassemble
the appliance correctly.
Adjusting the minimum setting for natural
or town gas
1. Light the burner and turn it to the minimum
position.
2. Extract the gas cock knob and turn the
adjustment screw next to the tap rod
(depending on the model) until the
correct minimum flame is achieved.
3. Refit the knob and verify that the burner
flame is stable.
4. Turn the knob rapidly from the maximum
to the minimum setting: The flame should
not go out.
5. Repeat the operation on all gas cocks.
The nozzle tightening torque must
be no more than 3 Nm.
