13-9
SECTION 13
SLIDEOUT ROOM
14 - SLIDEO
UT R
OOM
13 - SLIDEOUT ROOM
•
Do not open any of the four large T-handled
valves on the opposite end of the pump.
These regulate the coach leveling jacks
.
Step 2 - Crank the Room Inward
•
A wrench is used to crank the room inward.
You may use the ratchet wrench supplied
with the coach (in one of the storage compart-
ments) or any type of lug wrench of the same
nut size.
•
Crank-in bolts are located on the outboard
mounting plates of the slideout room as
shown. These plates are located at both ends
of the room inside the StoreMore
TM
compart-
ment doors.
•
Remove the locking pin from the crank-in
bolt shafts as shown before trying to turn the
bolts.
•
After removing the pin locks, fit the lug
wrench socket onto the bolt head and begin
cranking clockwise slowly a few turns, then
alternate to the other side for a few turns. This
can be sped up by using a helper and an addi-
tional lug wrench to crank both sides evenly
together.
Use provided 1/4” nut driver to turn nut
counterclockwise 4 turns only.
Slideout Room Solenoid Valve
Leveling Jack Valves - Do Not Open