SECTION 8 -
ENTERTAINMENT
8-6
TV SIGNAL AMPLIFIER
The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch located on a switchplate inside the front
overhead entertainment center cabinet.
An indicator light will glow when the switch
is on and the signal amplifier is active.
Checking Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter. Signals may vary from strong to no
usable signal at all. We recommend that the TV
system be checked out in an area known to have
good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
is working properly, the TV picture will now be
degraded (snowy). When you turn the switch
back on, the picture should again be sharp.
TV DIGITAL SATELLITE
SYSTEM WIRING
This coach is pre-wired for installation of a
digital satellite TV system. Coaxial cable
connections to hook up your satellite receiver are
located near the entertainment center cabinet.
A second connection may be included in an
overhead cabinet in the bedroom for the rear TV
(if equipped).
See your authorized Winnebago Industries
®
dealer for proper installation and sealing of roof
mounted components.
SATELLITE AND CABLE TV
HOOKUPS
The exterior satellite dish and cable television
input jacks are located in the utility or service
center compartment, depending on model.
TV Signal Amplifier Power Switch
(with 12-volt outlet and coaxial jack on wall plate
in front overhead entertainment compartment)
Power indicator
glows when signal
amplifier is active
Push On-Off
Interior Connection for Satellite Dish
(Located in cabinet near TV)
-Typical View