SECTION 8
APPLIANCES & INTERIOR FEATURES
8-16
Air Conditioner Filter (Coach models 38K &
40J)
A disposable furnace type filter is located in
the floor beneath the passenger side bedroom
night stand. It is visible behind the air grate in the
lower face of the night stand as shown. The filter
should be inspected monthly to ensure efficient
operation of the air conditioner system.
•
Remove the drawer from the nightstand to
access the filter.
•
Lift the old filter out the floor frame.
•
Lay the new filter back into floor frame,
being careful to observe flow markings on
the edge of the filter. The arrows should
point downward towards the floor.
NOTE: Do not block the filter intake grate in any
way by setting items such as packages,
blankets, etc., in front of it. There must be
free airflow for the air conditioner to op-
erate efficiently.
Condenser Coils
The condenser is located in a compartment
on the left side of the coach. The condenser is
the large, black, rectangular area that looks like a
car radiator.
Periodically sweep debris carefully from the
fins of the condenser. Rinse dust off with clean
water. The condenser coils must be clean and
free of dust, debris and insect particles, etc., for
the air conditioner to cool efficiently.
Further Information
See the air conditioner manufacturer’s operat-
ing instructions supplied in your Owners Info-
Case. They contain detailed operating
instructions, special precautions and basic trou-
bleshooting.
TV ANTENNA
The TV antenna on your motor home can be
easily raised, rotated a full 360
°
and lowered
from inside the vehicle by simply turning a crank
or rotating knob. A built-in signal amplifier de-
signed to strengthen signals, is controlled by a
power switch built into the TV jack assembly.
The signal amplifier is housed inside the an-
tenna with the circuit board connected directly to
the antenna elements. Power to operate the am-
plifier (12-volt DC) is supplied through the
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
Operation
Raising Antenna
- Turn elevating crank
clockwise in “UP” direction about 13 turns or
until some resistance to turning is noted. Antenna
is now in operating position. Turn amplifier pow-
er switch “ON” to receive TV signal.
Filter is visible through
front grate on nightstand
Remove nightstand
drawer to access filter
This symbol is used to alert you to
precautions that involve your per-
sonal safety as well as vehicle dam-
age. Read and follow them carefully.
WARNING
