SECTION 3 –
DRIVING YOUR MOTORHOME
3-14
topped up with the same type of coolant
as equipped to maintain the special long-
life properties.
Further Information
Refer to the chassis manual in your InfoCase
for information and precautions on filling,
servicing, and checking the fluid level.
CHASSIS BATTERY
DISCONNECT SWITCH
The Chassis Battery Disconnect switch
disconnects most chassis electrical loads from
the chassis (starting) batteries to avoid discharge
by constant draws such as engine computers,
radio clock, sensors, etc. (except the electric
entrance step). This feature is intended to help
conserve battery charge during storage.
Turn the switch to the OFF or ON positions to
disconnect or reconnect the chassis batteries.
NOTE: The Chassis Battery Disconnect switch
must be on to start the engine.
TIRES
Improper tire pressure can result in tire
overloading and abnormal wear and also affects
handling, ride characteristics, and fuel economy.
SUSPENSION ALIGNMENT
AND TIRE BALANCE
The front suspension and steering system of
this vehicle was factory aligned using highly
accurate equipment prior to delivery to the
dealership. However, alignment should be
checked and adjusted after you have fully loaded
NOTICE
When refilling the coolant system of a
vehicle equipped with a rear auxiliary
automotive heater and motoraid water
heater, be sure to allow for additional
coolant capacity of the heater and its
supply and return hoses.
WARNING
Make sure all replacement tires are of the
same size and rating as those shown on
your Vehicle Certification Label.
Chassis Battery Disconnect Switch
(Located near entrance door)
-Typical View
