8-7
SECTION 8 –
ENTERTAINMENT
TV SIGNAL AMPLIFIER
The TV signal amplifier is built into the
antenna and can be turned on or off with a power
switch on the video selection system (located on
a wall near the TV or in the entertainment center
cabinet, depending on model).
An indicator light will glow when the switch
is on and the signal amplifier is active.
Checking Amplifier Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the
transmitter (tower). Signals may vary from
strong to no usable signal at all. We recommend
that the TV system be checked out in an area
known to have good TV reception.
To check the antenna amplifier, raise the
antenna, select a TV channel, and rotate the
antenna for best picture. Then turn off the
amplifier power switch. If the antenna amplifier
is working properly, the TV picture will now be
degraded (snowy). When you turn the switch
back on, the picture should again be sharp.
CABLE TV HOOK-UP
The cable television connector is located in
the utility compartment.
TV DIGITAL SATELLITE
SYSTEM WIRING
This coach is pre-wired for installation of a
digital satellite TV system. Coaxial cable and
high definition component cable connections are
available to hook up your satellite receiver and
are located in the entertainment center cabinet.
See your authorized Winnebago Industries
®
dealer for proper installation and sealing of roof
mounted components.
CAUTION
To avoid equipment damage, always
align directional handle to DOWN position
before lowering. Never partially raise or
lower antenna. Antenna must be raised
fully up into operating position or lowered
fully down into travel position.
TV Signal Amplifier Switch on
Video Selection System
Cable TV Hook-Up
(Located in Utility Compartment)
-Typical View
Interior Connection for Satellite Dishes
(Located in cabinet near TV)
