Winnebago 2003 adventurer, Owner'S Manual

Page: 36 / 138

SECTION 2
DRIVING YOUR MOTOR HOME
2-12
MULTI-FUNCTION SIGNAL
LEVER
The multi-function signal lever controls the
turn signals, high/low beam changing, wind-
shield washer, wipers and wiper delay, and the
electronic speed control (cruise) on some models.
See your chassis operating guide for complete
operating information.
HEADLIGHT BEAM CHANGE
AND TURN SIGNALS
Move multi-function lever upward for right
turn signal and downward for left turn signal.
Pull end of handle toward you to switch high
beam to low, or low beam to high.
WINDSHIELD WIPERS AND
WIPER DELAY
See your chassis operating guide for complete
operating information.
CRUISE CONTROL
The electronic speed control (cruise) allows
you to maintain a steady speed and relieve driv-
ing strain while traveling long distances.
See your chassis operator manual for com-
plete instructions and precautions on the cruise
control.
COMFORT CONTROLS
AUTO AIR CONDITIONER/
HEATER
Controls for the air conditioner, heater, de-
froster and vent are all combined into one control
panel. Refer to the following instructions for use
of individual controls.
HEATING
A. For maximum heating
1. Turn the mode selection knob HEAT or
VENT.
2. Turn the temperature control knob to
WARM (red).
3. Place the fan switch to high (largest dot).
B. For reduced heating:
1. Turn the temperature control knob
toward the COOL (blue) zone to the
desired comfort position.
2. Adjust the fan speed for desired volume.
DEFROSTING
A. For maximum defrosting and defogging:
1. Turn the mode control knob to DEF.
Do not operate the cruise control on
icy or extremely wet roads, winding
roads, in heavy traffic, or in any other
traffic situation where a constant
speed cannot be maintained.
WARNING
Temp
Control
Mode
Selector
Fan Speed
Switch