Wingsland Miinivet, Quick Start Manual

Page: 4 / 14

Install Propellers and Flight Battery
Press two buttons simultaneously for 3 seconds (Figure 3) to light up the Flight Battery indicator
before the flight.
Push the battery into the battery compartment correctly to power on the aircraft directly.
Make sure insert into the bottom correctly and fasten the bayonet.
2
NOTICE
Toggle the switch L1 to the middle position:
Stabilized smooth GPS Mode. Toggle the
switch L1 to L1-0 position: Aerial Photography Mode.
Toggle the switch L1 to L1-1 position: Automatic Return-to-Home Mode (Aircraft would be flying higher
to 20M before return to the home point if the flight height is below 20M. Aircraft would be Return-to-Home
with maintaining the same flight height when the flight height is beyond 20M. The home point is the point
located during the GPS initialization. Make sure no obstacles along the way home before activating
Return-to-Home function.)
Toggle the switch L2 to the middle position: Standard Ready to Fly Mode. Toggle the switch L2 to L2-1
position: Forward Direction Lock Mode (The forward direction is a nose direction recorded after aircraft
powering on with the complete of GPS initialization)
.
Toggle the switch L2 to L2
-
0 position
:
POI Mode
( Record a Point of Interest
,
the aircraft can be controlled to circle around the POI
,
and the nose direction
always points to the POI
.)
Attaching propellers in the direction with consistence of arrow direction marked on the aircraft
arms(Figure 2). Spin and Fasten Screw Nuts with included small wrench (Figure 1).Check that
the propellers are installed correctly and firmly before every flight.
3
Figure 1
Attaching Propellers according
to the Arrow Direction
Green LED 1-5
Screw Nut
Screw Nut
Wrench
Press with holding for 3 seconds
Figure 3
Figure 2
Figure 4
Preparing the Remote Controller
Install Display Screen onto the Controller handle, press Display Screen Power Button for 3
seconds to powering on Display Screen. (Figure 1)
Set switch L1 (Figure 2) and switch L2 (Figure 3) to the middle position.
Install 6s AA Alkaline Battery into the battery compartment on the back of the Remote Controller.
Pay attention to positive and negative.(Figure 4 )
Reconfirm about every switch position. Place the antenna at the horizontal position pointing
to the left (Figure 4). Then turn on the Remote Controller (Figure 5).The Remote Controller
features a number of camera control functions, such as taking photos and videos, adjusting
camera setting, as well as controlling tilt of camera (Refer to Minivet User Manual for detail).
Display Screen
L2-0
Middle Position
L2-1
L1-0
Middle Position
L1-1
Switch On
Figure 1
Figure 3
Figure 2
Figure 5
Figure 4
Power Button
Press two triangular buttons once to check the flight battery capacity level. Ensure the battery
fully charged (Figure 4).
222