Set the Timer
8.
Loosen the 2 metal thumb screws and open
the timer door (fig 2).
Set Time of Day:
Press UP or DOWN button to
set hour and minute to current time.
Set Feed Times:
Press MODE button until
desired Timer number (1-4) appears in the
lower right hand corner of display. Press the
UP or DOWN button to adjust the Timer. See below section: “Set Run-Time” to customize
the amount of seed dispensed by each Timer.
Set Run-Time:
Press the MODE button again to display Run-Time. Press the UP or DOWN
button to adjust the Run-Time from 0 and 20 seconds.
(The longer the Run-Time, the more seed will be dispensed. Figure about 1/2 ounce per
second, depending on seed type.) To disable a Timer, set Run-Time to 0 seconds.
Manual Operation / Run-Time Test:
To test the amount of seed dispensed by a given Run-
Time, or to manually dispense seed, do the following: while the Run-Time is displayed,
press and hold the MODE button for about 3 seconds to start a test. Release MODE button.
After a 5 second countdown, the feeder will run for the number of seconds programmed.
9.
Close timer door and finger tighten the 2 thumb screws to secure door. Do not over
tighten.
Start Feeding
10.
Hang the AutoFeeder and let the feeding begin!
Maintenance and Care
11.
Do not run water through the inside AutoFeeder assembly. To clean, remove the
AutoFeeder assembly from the seed hopper. Use clean water to rinse out seed hopper and
dry with soft clean towel.
Customer Support
WINGSCAPES
150 Industrial Road
Alabaster, AL 35007
wingscapes.com
1-888-811-WING (9464)
1.5V SIZE
AA
UM3 OR LR6
MADE IN CHINA
1.5V SIZE
AA
UM3 OR LR6
1.5V SIZE
AA
UM3 OR LR6
1.5V SIZE
AA
UM3 OR LR6
PATENT PENDING
MODE
UP
DOWN
fig. 2
