![WinGD X82-B Maintenance Manual Download Page 717](http://html1.mh-extra.com/html/wingd/x82-b/x82-b_maintenance-manual_986581717.webp)
PROCEDURE
1
Remove all the protection from the sealing faces in the top housing (001,
and the exhaust valve control unit (VCU) (002).
2
Put oil on the new O-rings (009) and O-rings (010).
3
Attach the O-rings to the hydraulic pipe (004).
4
Make sure that the claws (007, 012) are correctly attached to the hydraulic pipe (004).
NOTE:
You can adjust the claws with an open-ended wrench.
5
Make sure that the distance X between the ends of the hydraulic pipe (004) and the
claws (007, 012) refers to
Table 13-2 - Distance X for hydraulic pipe exhaust valve
6
Apply oil to the threads of all the screws (008, 010).
7
Carefully put the hydraulic pipe (004) in position in the top housing (001) and the VCU
(002).
8
Torque symmetrically the screws (008) to the correct value, refer to section
9
Torque symmetrically the screws (010) to the correct value, refer to section
Tab 13-2
Distance X for hydraulic pipe exhaust valve
Engine type
Distance X [mm]
X35, X35-B
5.0
X40, X40-B
X40DF
5.0
X52
X52DF
5.5
X62, X62-B
X62DF
5.5
X72, X72-B
X72DF
5.5
X82, X82-B
X82DF
6.0
X92, X92-B
X92DF
9.5
X82-B
AA00-8460-00AAA-720A-A
Maintenance Manual
Hydraulic pipe exhaust valve - install
Winterthur Gas & Diesel Ltd.
- 717 -
Issue 001 2020-10
Summary of Contents for X82-B
