WinGD X62DF, Maintenance Manual

Page: 753 / 902

PROCEDURE
1 Remove all the protection from the sealing faces, the injection valve and the flow limiting
valve.
2 Attach new O-rings to the flanges (002, 006).
3 Apply Never-Seez NSBT to threads of the Allen screws (004 and 008, Figure 13-10 ).
4 Carefully put the HP injection pipe (001) in position in the injection valve (005) and the
flow limiting valve (003).
5 Torque symmetrically the four Allen screws (004) to the correct value, refer to section
16.1 Tightening instructions .
6 Torque symmetrically the four Allen screws (007) to the correct value, refer to section
16.1 Tightening instructions .
7 Make sure that the distance X between the flange (002, 006) and the end of the pipe
refers to
Table 13-3 - Distances X and Y for HP fuel pipe .
Tab 13-3 Distances X and Y for HP fuel pipe
Engine type Distance X [mm]
X52
X52DF
xxx
X62 / -B
X62DF
xxx
X72 / -B
X72DF
5.8
X92 / -B
X92DF
6.0
X72DF
AA00-8733-00AAA-720A-A
Maintenance Manual HP fuel pipe (fuel rail to injection valve) - install
Winterthur Gas & Diesel Ltd.
- 753 - Issue 002 2020-10