R Clip
pin
Set Screw
8
7
4.5"
4.5"
4.5"
4.5"
12"
1. Select the downrod
①.
There are two downrods of 4.5inch and 12inch in the package, customers can
choose according to the height of the house.
②.
The normal default is to install on the 4.5inch downrod.
③.
How to replace the 12 inch Downrod:
A. Loosen the two fixing screws (as shown in Figure 2).
B. Push the downrod upwards (as shown in Figure 3) out of the horizontal tip (as
shown in Figure 4).
C. Then pull out the 4.5 inch downrod to replace another 12 inch downrod
(as shown in Figure 5).
D. After replacement, follow the above installation steps 4-3-2 to install until it is
restored to the state shown in Figure 1.
E. Finally, you must pay attention that the two fixing screws must be firmly locked.
Note:
a
. According to the ceiling of different materials, use different screws to fix the
mounting bracket (as shown above).
b
. After the bracket is fixed, it must be determined to be able to bear the weight
of more than 60 kg(test pull by hand) for safety.
c
. Ceiling fans cannot be installed on gypsum ceilings
.
d. To reduce the risk of fire, electric shock, or personal injury mount to an outlet
box marked"Acceptable for Fan Support".Use the mounting screws provided
with the outlet box. Most outlet boxes commonly used for supporting lighting
fixtures are not acceptable for fan support and may need to be replaced.
Consult a qualified electrician if in doubt.
2. How to install Suspension Installation
①.
Remove the positioning screws from the fan body as follows and place them
side by side to proceed to the next step (Fig 6)
②.
Get off the pin off the downrod by remove the R clip, and get the lead wire
through the downrod and canopy, then seat the downrod into the fan body &
rotate the downrod until the holes on the downrod will match with the holes
on the fan body, finally, you should get the pin through the holes and fix the
pin by the R clip in another side (Fig 7)
③.
Tighten the two set screws removed previously.
Please use 8mm drill hole before installing with M6 expension screws
Notice: Make sure the fan blades at least 7 feet above the floor
1
2
3
4
5
6
3. Install the hanger bracket to the outlet box
a. Take off the screws on the outlet box.
b. Install the hanger bracket to the outlet box by screws
Decorative
cover
Coupling
cover
Coupling
cover
2. Concrete ceiling: First use an
∅
8mm hammer drill bit to drill the hole according to the
length of the expansion screw, then use the equipped expansion screws (2 Pieces) to
fix the bracket on the ceiling, and then tighten the nut of the expansion screw.
